Pull Brake Switch with Press-Fit Mounting Nut and Spring
Brake switch with included spring for electric; scooters, bikes, and go-karts.
Switch is normally open and closes when the pull rod is pulled. The spring is designed to go between the
pull rod and any part of the braking system which will pull on the spring when the brake
is engaged. The spring takes up any over-pull that the braking system exerts
on the switch to prevent pulling too hard on the brake switch's pull rod.
Threaded shaft mounts into a 12mm hole.
Mounting nut press-fits (push-locks) into a 14mm hole in panels up to 2mm thick.
Wires are 300mm (12") long.
Switch is 62mm long not including the pull rod.
Pull rod (plunger) is 7.5mm long and has a 1.5mm ID spring hole.
Spring is 160mm (6") long and made from zinc-plated spring steel.
Compatible connector item # CNX-51.
Item # SWT-102124
|
