Speed Controller SPD-36900A Installation and Wiring |
|
Rated Voltage | 12-36 Volts DC |
Rated For Motors | Up To 900 Watts |
Continuous Current Rating | 30 Amps |
Maximum Current Rating | None (Unlimited) |
Under Voltage Shutoff | 10 Volts ± 0.5 Volt |
Recommended Fuse/Circuit Breaker Size | Depends on Application |
Dimensions | 4" x 4-3/8" x 1-3/4" (L x W x H) |
Throttle | 3 Wire Hall-Effect Throttle (Included) |
Works with 12, 24, and 36 Volt Battery Packs: Multiple Voltage rated speed controller can be used with 12 Volt, 24 Volt, or 36 Volt battery packs. Under Voltage Shutoff: This controller's under Voltage shutoff value is 10 Volts ± 0.5 Volt. This shutoff value is too low for under Voltage protection of 24 and 36 Volt battery packs so using a Voltmeter to monitor the battery pack Voltage is recommended when using it with 24 and 36 Volt battery packs. Requires Heavy-Duty Switch or Contactor: This controller requires and external switch or contactor to turn it on and off. A heavy-duty disconnect switch such as item # SWT-700 or SWT-705 or power contactor such as item # RLY-24150 or RLY-36150 is needed to turn this controller on and off. Designed for Series Wound Motors: Works with permanent magnet motors however if used with a permanent magnet motor the motor may make a buzzing sound while it is running. |
*Power Connector
|
|
Motor
Connector
|
|
Throttle Connector
(Built Into Controller) 1 = +5 Volts Output 2 = +1-4 Volts Input 3 = -Negative
|
Required Connection |
|
*The power should be the last connection made. *Power switch or power contactor and fuse or circuit breaker need to be installed between the speed controller and battery pack. |