Speed Controller SPD-SD1000-6 Installation and Wiring

Rated Voltage   36 Volts
Rated For Motors   Up To 1000 Watts
Maximum Current   40 Amps
Under Voltage Protection   31 Volts ± 1.0 Volts
Recommended Fuse Size   40 Amps
Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 31 Volts ± 1.0 Volts)
Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor.

*Power Connector
Red = Positive
Black = Negative

Mating Connector Item # CNX-2PX2


Required Connection

Motor Connector
Blue = Positive
Green = Negative

Mating Connector Item #CNX-50

Required Connection
Throttle Connector
Mating Throttle Item # THR-600

Required Connection
Brake Lever Switch Connector
Mating Connector Item # CNX-51

~Optional Connection
Charger Port Connector

Connect to positive lead of battery charger port. Prevents motor from operating when battery pack is charging.

Mating Connector Item # CNX-45


~Optional Connection
*The power connector should be the last connection made.
*Fuse or circuit breaker protection is required between speed controller and battery pack.
~Optional Connections do not need to be hooked up for the speed controller to operate.