Speed Controller SPD-36750A Installation and Wiring |
|
Rated Voltage | 36 Volts |
Rated For Motors | Up To 750 Watts |
Maximum Current | 30 Amps |
Rated For Chargers | Up To 3 Amps |
Conversion Efficiency | 95% |
Under Voltage Protection | 31 Volts |
Recommended Fuse Size | 35 Amps |
Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller
turns the motor off preventing over discharging of the battery pack
which extends the battery packs lifespan. (The cutoff value is
approximately 31.0 Volts ± 1.0 Volts) Motor Cut-Off During Braking: When the brakes are applied the brake switch signals the controller to turn off the motor. This feature is optional. To disable leave brake lever switch connector unplugged. |
*Power Connector |
Required Connection |
---|---|
Motor
Connector Blue = Positive Green = Negative Mating Connector Item # CNX-50 |
Required Connection |
Throttle/Battery
Gauge
Connector Throttle = Red, Black, Green Battery Gauge = Orange, Grey Mating Connector Item # CNX-65 |
Throttle is Required Connection ~Battery Gauge is Optional Connection |
Brake Lever Switch Connector Mating Connector Item # CNX-51 |
~Optional Connection |
Battery Charger Connector Connects to positive lead of battery charger port and disables motor when the battery pack is being recharged. Mating Connector Item # CNX-45 |
~Optional Connection |
*The power connector
should be the last connection made. *Fuse or circuit breaker protection is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |