Speed Controller SPD-36500C Installation and Wiring

Rated Voltage   36 Volts
Rated For Motors   Up To 500 Watts
Maximum Current   25 Amps
Conversion Efficiency   95%
Under Voltage Protection   31 Volts
Recommended Fuse Size   25 Amps
Dimensions   4" x 3" x 1-5/8"
Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 20.5 Volts ± 1.0 Volts)
Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. The motor turns on again after the brakes are released.

*Power Connector
Red = Positive
Black = Negative

Mating Connector Item # CNX-09S


Required Connection
 

Motor Connector
Yellow = Positive
Green = Negative

Mating Connector Item # CNX-09S

Required Connection
 
Throttle Connector

Mating Connector Item # CNX-5
2

Required Connection
 
Key / Power Switch Connector

Mating Connector Item # CNX-09S

Required Connection
 
Speed Meter Connector
Green = Positive

Mating Connector Item # CNX-09S
 
~Optional Connection
Brake Lever Switch Connector

Mating Connector Item # CNX-51

~Optional Connection
Speed Limit Adjustment

Motor speed Is adjustable from full stop to full speed and everywhere in between.

*The power connector should be the last connection made.
*Fuse or circuit breaker protection is required between speed controller and battery pack.
~Optional Connections do not need to be hooked up for the speed controller to operate.