Speed Controller SPD-36500A Installation and Wiring |
|
Rated Voltage | 36 Volts |
Rated For Motors | Up To 500 Watts |
Maximum Current | 25 Amps |
Rated For Chargers | Up To 3 Amps |
Conversion Efficiency | 95% |
Under Voltage Protection | 31 Volts |
Recommended Fuse Size | 30 Amps |
Dimensions | 3-5/8" Wide x 2-1/4" Long x 1-3/8" High |
Sealed Design:
This speed controller is factory sealed with black silicone sealant
around its wires and case seams to prevent water intrusion.
Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller
turns the motor off preventing over discharging of the battery pack
which extends the battery packs lifespan. (The cutoff value is
31.0 Volts ± 1.0 Volts) |
*Power Connector |
|
Motor
Connector |
Required Connection |
Throttle Connector
Mating Connector Item # CNX-52 |
Required Connection |
Key
Switch Connector
Mating Connector Item # CNX-51 |
Required Connection |
Battery Charger Connector |
~Optional Connection |
Battery Gauge
Mating Connector Item # CNX-51 |
~Optional Connection |
Brake
Lever Switch Connector
Mating Connector Item # CNX-51 |
~Optional Connection |
Brake
Light Connector
Mating Connector Item # CNX-51 |
~Optional Connection |
*The power connector
should be the last connection made. *Fuse or circuit breaker protection is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |