Speed Controller SPD-36500 Installation and Wiring

Rated Voltage   36 Volts
Rated For Motors   Up To 500 Watts
Maximum Current   25 Amps 
Rated For Chargers   Up To 3 Amps
Conversion Efficiency   95%
Under Voltage Protection   31 Volts
Recommended Fuse Size   30 Amps
Dimensions   3-5/8" Wide x 2-1/2" Long x 1-1/4" High
Sealed Design: This speed controller is factory sealed with black silicone sealant around its wires and case seams to prevent water intrusion.

Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is 31.0 Volts ± 1.0 Volts)
Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. Connecting a brake switch to this controller is an optional connection.

*Power Connector
Red = Positive
Black = Negative

Mating Connector Item # CNX-50


Required Connection

Motor Connector
Yellow = Positive
Blue = Negative


Mating Connector Item # CNX-50


Required Connection
Throttle Connector

Mating Connector Item # CNX-52


Required Connection
Key Switch Connector

Mating Connector Item # CNX-51


Required Connection

Battery Charger Connector
Red = Positive
Black = Negative

Mating Connector Item # CNX-51


~Optional Connection
Battery Gauge

Mating Connector Item # CNX-51


~Optional Connection
Brake Lever Switch Connector

Mating Connector Item # CNX-51


~Optional Connection
Brake Light Connector

Mating Connector Item # CNX-51


~Optional Connection
*The power connector should be the last connection made.
*Fuse or circuit breaker protection is required between speed controller and battery pack.
~Optional Connections do not need to be hooked up for the speed controller to operate.