Speed Controller SPD-24500B Installation and Wiring

Rated Voltage   24 Volts
Rated For Motors   Up To 500 Watts
Maximum Current   30 Amps
Rated For Chargers   Up To 3 Amps
Conversion Efficiency   95%
Under Voltage Protection   20.5 Volts
Recommended Fuse Size   40 Amps
Dimensions   3-1/4" x 2-9/16" x 1-1/2"
Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 20.5 Volts ± 1.0 Volts)
Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. The motor turns on again after the brakes are released.
Note About Connectors: The Charger Port and Brake Light connectors with black and red wires have printed labels on them that say what their functions are. These labels are facing down and not visible in the photograph of the controller shown above. The Power Light connector with black and red wires does not have a printed label on it.

*Power Connector

Red = Positive
Black = Negative

Mating Connector Item # CNX-50


Required Connection
 

Motor Connector
Blue = Positive
Yellow = Negative

Mating Connector Item # CNX-50

Required Connection
 
Throttle Connector
Red = + 5 Volts Output
Black = Negative
Blue = 1-4 Volts Input

Mating Connector Item # CNX-5
2

Required Connection
 
Key Switch Connector

Mating Connector Item # CNX-51

Required Connection
 
Battery Charger Connector
Black = Negative
Red = Positive

Mating Connector Item # CNX-51
 
~Optional Connection
Brake Lever Switch Connector

Mating Connector Item # CNX-51

~Optional Connection
Brake Light Connector

Mating Connector Item # CNX-51

~Optional Connection
Power Light Connector

Mating Connector Item # CNX-51

~Optional Connection
*The power connector should be the last connection made.
*Fuse or circuit breaker protection is required between speed controller and battery pack.
~Optional Connections do not need to be hooked up for the speed controller to operate.