Speed Controller SPD-24350B Installation and Wiring |
|
Rated Voltage | 24 Volts |
Rated For Motors | Up To 350 Watts |
Maximum Current | 25 Amps |
Rated For Chargers | Up To 3 Amps |
Conversion Efficiency | 95% |
Under Voltage Protection | 20 Volts ± 0.5V |
Recommended Fuse Size | 30 Amps |
Dimensions | 3-1/4" x 2-9/16" x 1-1/2" |
Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller turns the
motor off preventing over discharging of the battery pack which extends the
battery packs lifespan. (The cutoff value is 20 Volts ± 0.5 Volts) Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. The motor turns on again after the brakes are released. |
*Power Connector Red = Positive Black = Negative Mating Connector Item # CNX-50 |
Required Connection |
Motor Connector Blue = Positive Yellow = Negative Mating Connector Item # CNX-50 |
Required Connection |
Throttle Connector Red = + 5V Output Black = Negative Blue = + 1-4V Input Mating Connector Item # CNX-52 |
Required Connection |
Key Switch Connector Mating Connector Item # CNX-51 |
Required Connection |
Battery Charger Connector Red = Positive Black = Negative Mating Connector Item # CNX-51 |
~Optional Connection |
Brake Lever Switch Connector Mating Connector Item # CNX-51 |
~Optional Connection |
Brake Light Connector Mating Connector Item # CNX-51 |
~Optional Connection |
Power Light Connector Mating Connector Item # CNX-51 |
~Optional Connection |
*The power connector should be the last connection made. *Fuse or circuit breaker protection is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |