Speed Controller SPD-24150 Installation and Wiring

Rated Voltage   24 Volts
Rated for Motors   Up To 150 Watts
Maximum Current   15 Amps
Rated for Chargers   Up To 3 Amps
Conversion Efficiency   95%
Under Voltage Protection   20.5 Volts
Recommended Fuse or Breaker Size   15 Amps
Dimensions   3" Long x 2-3/8" Wide x 1-1/2" High
Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 20.5 Volts ± 1.0 Volts)
Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. The motor resumes running when the brake is released.
*Power Connector
Red = Positive
Black = Negative

Mating Connector Item # CNX-50


Required Connection

Motor Connector
Blue = Positive
Yellow = Negative

Mating Connector Item # CNX-50

Required Connection
Throttle Connector
Red = + 5 Volts Output
Black = Negative
Green = 1-4 Volts Input

Mating Connector Item # CNX-52

Required Connection
Key Switch Connector

Mating Connector Item # CNX-51

Required Connection
Battery Charger Connector
Black = Negative
Red = Positive

Mating Connector Item # CNX-51

~Optional Connection
Brake Light Connector

Mating Connector Item # CNX-51

~Optional Connection
Brake Lever Switch Connector

Mating Connector Item # CNX-51

~Optional Connection
Power Light Connector

Mating Connector Item # CNX-51

~Optional Connection
*The power connector should be the last connection made.
*Fuse or circuit breaker protection should be installed between speed controller and battery pack.
~Optional Connections do not need to be hooked up for the speed controller to operate.