Speed Controller SPD-CT312C1-3 Installation and Wiring |
Rated Voltage | 36 Volts |
Rated For Motors | Up To 650 Watts |
Maximum Current | 30 Amps |
Rated For Chargers | Up To 3 Amps |
Conversion Efficiency | 95% |
Under Voltage Protection | 31.5 Volts |
Recommended Fuse Size | 36 Amps |
Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller
turns the motor off preventing over discharging of the battery pack
which extends the battery packs lifespan. (The cutoff value is
approximately 31.5 Volts ± 1.0 Volts) Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. |
*Power Connector Thick Red = Positive Thin Red = Positive
|
Required Connection |
Motor
Connector Yellow = Positive Blue = Negative Mating Connector Item # CNX-50 |
Required Connection |
Throttle/Battery Gauge Connector Throttle = Red, Black, Green |
Throttle is a Required Connection ~Battery Indicator is an Optional Connection |
Battery Charger Connector Red = Positive Black = Negative Mating Connector Item # CNX-51 |
~Optional Connection |
Brake Lever Switch Connector 1 Mating Connector Item # CNX-51 |
~Optional Connection |
Brake Lever Switch Connector 2 Mating Connector Item # CNX-51 |
~Optional Connection |
*The power connector
should be the last connection made. *Fuse or circuit breaker protection is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |